三马致力于打造优质传动设备蜗轮蜗杆
Before installing worm gear reducer, matters needing attention:
1. the machine should be cleaned before installation. And check whether there are bruises and dirt on the installation shaft, if all should be cleaned.
2. the use temperature of the reducer is 0~40 C.
3. check whether the matching dimensions of the coupling hole of the reducer and the reducer meet the requirements, and the hole tolerance should be H7.
4. Before use, the plug at the highest position should be replaced by the exhaust plug to ensure that the gas in the body is discharged when the reducer is running.
1. the machine should be cleaned before installation. And check whether there are bruises and dirt on the installation shaft, if all should be cleaned.
2. the use temperature of the reducer is 0~40 C.
3. check whether the matching dimensions of the coupling hole of the reducer and the reducer meet the requirements, and the hole tolerance should be H7.
4. Before use, the plug at the highest position should be replaced by the exhaust plug to ensure that the gas in the body is discharged when the reducer is running.
Next:
Common causes and solutions of worm gear reducer Previous:
Various trial run of worm gear reducer
News Center
Commend Products
Contact
Hotline
400-026-9834
